Excavating is one of the most hazardous construction operations and the Occupational Safety and Health Administration (OSHA) has stringent guidelines aimed at protecting employees involved in the work. In particular, cave-ins rank at the top of the list of hazards facing employees.
OSHA is aware that a number of factors make it difficult to design protection against cave-ins, including soil classification, depth of cut, the water content of soil, changes due to climate and other operations in the vicinity. Consequently, the agency allows several different prevention methods including:
1. Supporting the sides of the excavation.
2. Sloping, or benching. This method involves sloping the sides of an excavation to an angle not steeper than one and one-half horizontal to one vertical (34 degrees measured from the horizontal). These slopes must be excavated to form configurations that are in accordance with those for Type C soil found in Appendix B of the standard. A slope of this gradation or less is considered safe for any type of soil.
All simple slope excavations 20 feet or less in depth in Type C soil have a maximum allowable slope of 1 1/2:1.
Another method, which can be applied for both sloping and shoring, involves using tabulated data, such as tables and charts, approved by a registered professional engineer. These data must be in writing and must include sufficient explanatory information to enable users to make a selection.
At least one copy of the information documents, including the name of the registered professional engineer who approved the data, must be kept at the worksite during construction of the protective system. Upon completion of the system, the data may be stored away from the job site, but a copy must be made available, upon request, to OSHA officials.
3. Placing a shield between the side of the excavation and the work area. Contractors also may use a trench box or shield that is either designed or approved by a registered professional engineer or is based on tabulated data. Timber, aluminum, or other suitable materials may also be used.
OSHA standards permit the use of a trench shield (also known as a welder's hut), as long as it provides protection equal to or greater than what would be provided by the appropriate shoring system.
Before excavation actually begins, OSHA requires employers to:
Warning: OSHA cautions that: "No matter how many trenching, shoring and backfilling jobs have been done in the past, each job should be approached with the utmost care and preparation."
In one case that illustrates the penalties that can be imposed, OSHA fined a Houston construction company nearly $100,000 for violating standards to protect employees from cave-ins.
Regulators determined that the shoring system wasn't designed to protect employees working at a depth greater than 25 feet.
The agency alleged that the company failed to:
OSHA's charges included both willful and serious violations of safety standards. A "willful violation" is intentional disregard of, or indifference to, regulations set by the Occupational Safety and Health Act. A "serious violation" indicates the company knew, or should have known, that the hazard had a high probability of resulting in death or serious injury.
Get in touch today and find out how we can help you meet your objectives.
